HVAC Installation in Daphne, AL
A new system here will heat from November through March and cool from May through October every year. Tell us about the house, and a licensed contractor who covers Baldwin County will get in touch.
Tell us about the job
It takes about a minute.
Eleven months of the year, one system or the other is running
Winters here are short and mild, with nights averaging 43°F from December through February. Summer runs longer and works harder, with afternoons averaging 90°F from May through October. Between the two, a heating and cooling system in Daphne is doing one job or the other 11 months a year, with barely a break in between.
Most homes here heat with electricity, so the system you install has to carry both loads well, not just one. And with 109 damaging wind events recorded in Baldwin County over the past ten years, and close to a fifth of Alabama households losing power for a day or more in 2024, it is worth asking any contractor you talk to how the system you choose comes back on once the power does.
- 5 months
- November through March, your system heats
- 6 months
- May through October, it cools
- 43°F
- the average winter night it heats against
- 90°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Alabama requires HVAC contractors to hold a state license.
The Alabama Board of Heating, Air Conditioning & Refrigeration Contractors licenses the contractor, not the job. That means the person installing your system has been tested by the state and is on record with the board. It does not mean the board checks each installation once the contractor is licensed. The license speaks to who is doing the work, not to how any one job turns out.
For an installation in Baldwin County, that license is what stands behind the contractor. The inspection of the actual work falls to the local building office, not the board. Most cities and counties here require a permit before a furnace, air conditioner or heat pump goes in, and an inspection once it's done, and that inspection is what checks the installation itself against code.
Source: Alabama Board of Heating, Air Conditioning and Refrigeration Contractors
- When should I replace my HVAC system?
- Replace it once repairs start costing more than they are worth or the system can no longer keep the house comfortable. A contractor can look at the age and condition of a furnace or air conditioner and tell you how much life is left in it. If you are calling for a repair more than once a year, that is usually the point to start planning a replacement instead of patching it again. Homes here run the air conditioner six months a year and the furnace five, so both sides of the system get real use and wear at a similar pace.
- Should I replace my furnace and air conditioner at the same time?
- If the two are close in age, yes, replacing them together usually makes sense. A furnace and air conditioner installed at the same time are matched to work as one system, and pairing an old unit with a new one can mean the old part drags down the new one. It also means one installation instead of two separate jobs down the road. A contractor can check the age and condition of each unit and tell you whether replacing both now or waiting on one makes sense for your house.
- What happens during an HVAC installation?
- A contractor removes the old equipment, sets the new furnace or air conditioner in place, and connects it to the ductwork, the gas or electric line, and the condensate drain. They check the ducts for leaks or damage and confirm the new equipment is sized right for the house, since a unit that is too big or too small will not heat or cool evenly. Once it is connected, they test it, check refrigerant levels or gas pressure, and walk through the thermostat settings with you. A contractor can tell you upfront how long the job will take for your specific house and system.